DHCP issue when using 3rd Party Bridge

Unanswered Question

I have a WLC 4404 running 4.1.192.22M(Mesh). I have 20 1522's currently and all seems to be working great until I try to connect a client through a bridge device. The end device cannot obtain an IP address via DHCP, the request goes out, but the response is never received.

The bridge device is functioning correctly because if I assign a static IP to the client in the correct subnet it passes traffic no problem.

I've looked at the workgroup bridge functionality but that looks like it only works when using a cisco device on the 'client' end. In my application (WISP) I don't want or need Cisco AP's at every client location.

It doesn't make sense to me why a 3rd party bridge will work fore seemingly all traffic accept DHCP assignments. Any help would be appreciated.

I have read many posts on these forums that discuss this same subject but none seem to have definitive answers.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode