Cisco 15305+E100-WAN-8

geekmindart · ‎07-08-2008

Hi.

I just received two Cisco 15305 and E100-WAN-8 modules. For now I need to do a simple scheme. cisco's 15305 connected between each other through optical fiber

I have two laptops connected to E100-WAN-8 module with both sides. I just need that laptops to ping each other.

please help!

ps

sorry for my bad English

geekmindart · ‎07-09-2008

I don't ask complete istruction how to do that..at least some basic steps, please.

ps

and I fogot to say about optical module

STM-4 L4.2-2-LC through which 15305 connected

geekmindart · ‎07-10-2008

ok. point-to-piont connection is work on layer 1. But in the end I need Point-to-Multipoint Ethernet Connection.

Here is the theory - http://www.cisco.com/en/US/products/hw/optical/ps2001/products_white_paper09186a008021dea6.shtml

But how practicaly to do that? I need something like in Figure 4.

axxessit · ‎12-12-2008

The easiest is to configure a L1 circuit.

Set the Eth port to L1. This will provide access to configuration of the VCG for Ethernet over SDH services.