07-09-2008 12:27 AM - edited 03-03-2019 10:39 PM
Hi All
I have two sites A & B connected as below:
A(4507 switch) <-------------> B (2970 switch) <-----> B (2811 router)
Gig port of 4507 switch of Site A is connected to 2970 switch of site B. 2970 switch of site B is connected to 2811 router at same site.
I have created a sub-interface on router. I have assigned /30 IP address on 4507 and on router su-interface. The connectivity is running fine. I am able to ping router from switch and vice versa.
Now, I want to do NAT between sites. The IP pool at site A: 10.10.10.0/24, Pool at B: 192.168.1.0/24, Pool for NAT: 10.10.20.0/24
At site A: I have defined a route for 10.10.20.0/24 towards site B router.
At site B: I have defined a route for 10.10.10.0/24 towards site A switch. Also I have done a static nat of 192.168.1.1 to 10.10.20.1. But I am not able to ping 10.10.20.1 from site A.
My question is, as the sub-interface of the router have incoming and outgoing traffic; what shall I define on it "ip nat inside" or "ip nat outside" or if I am doing something wrong ?
regards/bsn
07-09-2008 01:12 AM
regarding your question
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094430.shtml
07-09-2008 01:50 AM
Thanks for replying, but I am not able to co-relate or configure my scenario. Please help.
07-09-2008 04:22 AM
Can somebody help please !!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: