cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
489
Views
0
Helpful
3
Replies

Error when trying to configure QOS on interface

exxonmiidris
Level 1
Level 1

Folks,

I received this error when trying to configure service policy out from interface.

Router(config)#int fa3/4

Router(config-if)#service-policy output SETDSCP

QoS: FastEthernet3/4 doesn't support policy SETDSCP for class VOICE in Out direction

router(config-if)#

3 Replies 3

webstd.design
Level 1
Level 1

Can you share the class-map and policy-map config?

Nagendra Kumar Nainar
Cisco Employee
Cisco Employee

This message is thrown if the policy is not supported in out direction.

Can you let us know which platform it is?. Also it would be better if you can paste the policy-map, class-map config.

Regards,

Nagendra

pcameron
Cisco Employee
Cisco Employee

Could be related to this -

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/qos.html#wp1720400

Policers can act on ingress traffic per-port or per-VLAN. With a PFC3, for egress traffic, the policers can act per-VLAN only

You will have to give us a bit more information about platform/IOS versions etc ... if you want a more detailed answer.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: