07-09-2008 04:23 AM - edited 03-06-2019 12:05 AM
Every time I save a configuration with "write memory" or "copy running-config startup-config" the router doesn't keep its settings when I turn it off. When it comes back on it just asks me if I want to enter initial setup. Then I have to manually copy the startup-config into the running config. What's wrong?
07-09-2008 04:26 AM
check config-register
sh ver
should be 0x2102
conf t
config-register 0x2102
end
wr
reload
07-09-2008 04:26 AM
Hi,
Check if the config-register is 0x2142. If so, it will skip the startup config while booting. Change the same to "config-register 0x2102"
HTH,
Nagendra
07-09-2008 04:36 AM
Thanks guys. That did the trick.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: