Unable to access LAN on 871 EasyVPN Server

Unanswered Question
Jul 9th, 2008
User Badges:

I am new to Cisco equipment, so am using the 871W Router for learning. I used the SDM to setup the Easy VPN Server.


I can connect no problem using the Cisco VPN Client. However once connected, I am unable to access any of the resources. If I ping 10.5.1.30, my printer, it times out.


If I monitor the terminal I don't see anything. Looking at the statistics in the client, I see encrypted packets but no decrypted packets. It appears the request is being sent through the tunnel but not reaching the 10.5.1.0/24 network.


Attached is my configuration, any help is appreciated!



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tahequivoice Thu, 07/17/2008 - 11:58
User Badges:

I wasnt able to see your config, the server is throwing errors, but when you set up the VPN for the remotes, did you setup a different pool of IP addresses for them? They should not be out of the same subnet of IP's.


ip local pool 10.5.2.1-10.5.2.254 netmask 255.255.25.0


I dont care too much for SDM since I have been using the CLI for over 10 years now. The SDM just confuses me. It is great however for troubleshooting.

Actions

This Discussion