Please few steps on how to config a CCM 6.1.2

Unanswered Question
Jul 9th, 2008

Hi guys,

I will need few steeps on how to setup a call manager 6.1.2 with a 2811 as a gateway. I'm very new with Call Manager and I have to finish this project till Friday. Please help me,

So I have:

1 - 2811 with 1MFT T1/E1 and 8 FXO

1 - 7816 server running Call Manager 6.1.2

What I have done:

- Installed call manager and uploaded the license files (500 seats, 200 units)


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Wed, 07/09/2008 - 14:19

Maintain and Operate Guides

download :

Cisco Unified Communications Manager Administration Guide, Release 6.1(1)

look at the GW config part, you do not mention which protocol you want to use so look at the appropriate doc

Configuration Examples and TechNotes



if this helps, please rate

Michael Ciulei Thu, 07/10/2008 - 01:35

Thanks javalenc for the links.

I still am little bit confused with all the info that I have to read.

I will use MGCP as protocol for gateway.

But I don't know how to config the gateway. If someone can put a running config I will appreciate a lot.

I don't know if I must put the phone firmwares on the gateway CF, or what exactly I have to do.

I have some experience with Call Manager Express but I don't know what from that experiense to use.

Jaime Valencia Thu, 07/10/2008 - 05:29

guess you only looked at one link since in here:

Configuration Examples and TechNotes

there are a LOT of examples:

# Configure MGCP Gateway and FXO/FXS Ports on a Cisco CallManager Server


# Configuring Cisco CallManager with IOS MGCP Gateways (Analog FXO, FXS Ports)


# Configuring SRS Telephony and MGCP Fallback


# Configuring the Cisco IOS MGCP Gateway


# Hookflash Transfer in MGCP


# How to Configure MGCP with Digital PRI and Cisco CallManager

did you checked any of those?????



if this helps, please rate


This Discussion