calls getting disconnected when going over E1 PRI QSIG to Avaya PBX

snzeadibe · ‎07-10-2008

I am implememnting the integration of call manager 6.1 to Avaya Definity G3R PBX.After the configuration when a call is placed from Avaya to Cisco it goes through but when a call is placed from cisco to avaya i get this message.

*Jul 10 08:01:49.503: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x0001

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98381

Exclusive, Channel 1

Facility i = 0x9FAA06800100820100A112020100020100800A4964726973204D757361

Calling Party Number i = 0x0081, '6357'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '326'

Plan:Unknown, Type:Unknown

*Jul 10 08:01:49.543: ISDN Se0/0/0:15 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x8001

Cause i = 0x81D8 - Incompatible destination

indly help sort out this problem because it is having a serious (critical )delay in business

snzeadibe · ‎07-10-2008

Can anybody help. plssss

tomide_ccie · ‎07-10-2008

try this:

isdn switch-type primary-dms100

isdn protocol-emulate network

isdn incoming-voice voice

isdn T306 60000

isdn bind-l3 ccm-manager

you may need to change the pri protocol if avaya doesn't support dms100, the configuration above is for Nortel, i had same issue and this config fixed it.

snzeadibe · ‎07-10-2008

it is still the same reorder tone.cant call the avaya

andrejrudas · ‎07-10-2008

What device terminate ISDN on other side from Avaya?

If it is some cisco device check your pots dial-peer configuration, and try "no digit-strip".

--

Andrew