Calls between Device Pools

Unanswered Question
Jul 10th, 2008
User Badges:

hi all,

I need to create two different Device Pools in one Call Manager 4.2(3) but when I do that the phones in one Device Pool Can't call to phones in the other one device Pool. All calls inside device pool works fine.

Any ideas?


thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Thu, 07/10/2008 - 05:32
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

codecs must be the issue


HTH


javalenc


if this helps, please rate

carlosjlopez Thu, 07/10/2008 - 05:42
User Badges:

Hi Javalenc, thanks for your fast answer, both device pools are in the same region and use the same codec G711

Chris Deren Thu, 07/10/2008 - 05:38
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

What is the location set to on the DPs? If it's different ensure that the location configuration has enough bandwidth for the calls.

Also, what type of phones are these?


Chris

Jaime Valencia Thu, 07/10/2008 - 05:50
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

as far as i remember location is set on the device and not in the DP. but might be a good idea to check it anyway


what happens when you dial?? what do you hear??


HTH


javalenc


if this helps, please rate

Chris Deren Thu, 07/10/2008 - 06:09
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

In CM 4.2 and 6.X it is set in Device Pool.


Chris

Ayodeji Okanlawon Thu, 07/10/2008 - 06:41
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

In CCM 4.2 and 6.X you can set the location on both the DP and the Device itself!


So please check what locations you have on both and ensure you have enough badnwidth for the call

Actions

This Discussion