cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1290
Views
3
Helpful
4
Replies

Syslog messages only from vlan and trunk interfaces

cmartinvalle
Level 1
Level 1

Hi,

I have LMS 2.6 and we have configured syslog in our 100 devices for sending syslog messages to the LMS.

Now we want to configure CiscoWorks for sending mails when a VLAN or a trunk interface goes down or up, but not any interface, only vlan or trunks.

How could we do it?

Thank you very much.

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

There is no way to do this unless you want to create Automated Actions for each device, and match on a known list of VLAN/trunk port interfaces.

That said, assuming your switches are running recent enough code, you could use the Embedded Event Manager to do this directly from the device.

View solution in original post

4 Replies 4

Joe Clarke
Cisco Employee
Cisco Employee

There is no way to do this unless you want to create Automated Actions for each device, and match on a known list of VLAN/trunk port interfaces.

That said, assuming your switches are running recent enough code, you could use the Embedded Event Manager to do this directly from the device.

yjdabear
VIP Alumni
VIP Alumni

For Vlan updowns only:

Facility : LINK

Sub-facility : *

Severity : *

Mnemonic : UPDOWN

Description : Interface Vlan*changed state to*

Thanks but the pattern "vlan" never appears in the syslog messages, always "GigabitEthernet..." or "FastEthernet...".

Actually, the IOS would create syslog messages if "logging link-status" is configured under each VLAN interface, or globally.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: