ACS Appliance 1113 with v4.2

stanleyworks · ‎07-10-2008

I have ACS appliance 1113 with v4.2 software. How do I tight this into Active directory? Do I have to run some software on the DC server?

Thanks,

Jagdeep Gambhir · ‎07-11-2008

You need to install remote agent on member server. The software will facilitate communication between acs and AD.

Here is the link,

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.1/installation/guide/remote_agent/rawi.html

Regards,

~JG

Do rate helpful posts

h.estigarribia · ‎10-29-2008

Just to confirm, I also have the same scenario, to integrate with Active Directory I need the Remote Agent installed in the AD server itself? I configured as Generic LDAP and I can see the groups within my AD but instead I need to configure it as Windows Database?

Thanks