Dial Peer Configuration Help

Unanswered Question
Jul 10th, 2008
User Badges:

On an H323 gateway what dial peer do I need to configure to route an inbound 800 number that is coming in on a CAS T-1 sending the last four digits as the DNIS. Currently this T-1 is only being used for outbound traffic.


Dianna

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Thu, 07/10/2008 - 11:08
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Like:


dial-peer voice 1234 voip

destination-pattern 1234

session target ipv4:x.x.x.x

codeg g711u

no vad

dtmf-relay rtp-npe


Please rate post if it does!

dfhensley Thu, 07/10/2008 - 11:22
User Badges:

This didn't work for me. When calling the number I get dead air, no ring back.


Thanks

Ayodeji Okanlawon Thu, 07/10/2008 - 11:43
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

can you post your full config here

paolo bevilacqua Fri, 07/11/2008 - 01:53
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Does the CM knows about the called DID?

Next step would be debugs like "cch323" with "term mon".

Ayodeji Okanlawon Fri, 07/11/2008 - 09:30
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

Your dial-p voice 411 below specifies a 4 digit number. However you said the inbound number is 800


can you tell me the full number delievered to your gateway.


You can know this by doing a dbug isdn q.931 and place a test call to the number...


dial-peer voice 411 voip

destination-pattern [0-8]...

progress_ind setup enable 3

modem passthrough nse codec g711ulaw

session target ipv4:10.34.0.11


dfhensley Fri, 07/11/2008 - 09:52
User Badges:

This is the message I got when I did the debug and called the number. Telco is suppose to be sending 4191 as the dnis. The whole number is 877-367-4191


Thanks,

Dianna



Jul 11 13:46:09.132: ISDN Se0/0/1:23 Q931: TX -> CONNECT pd = 8 callref = 0x807D

Jul 11 13:46:09.168: ISDN Se0/0/1:23 Q931: RX <- CONNECT_ACK pd = 8 callref = 0x007D

Jul 11 13:46:09.168: ISDN Se0/0/1:23 **ERROR**: call_progress: DEV_CONNECTED VOICE ERROR: Bearer capability not available(0x3A): b channel 2 call id 0

x28CC


Ayodeji Okanlawon Fri, 07/11/2008 - 10:04
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

I need to see the full debug..including the part that showed the calling and called number and also the cuase code..


send the full output


Actions

This Discussion