Dial Peer Configuration Help

dfhensley · ‎07-10-2008

On an H323 gateway what dial peer do I need to configure to route an inbound 800 number that is coming in on a CAS T-1 sending the last four digits as the DNIS. Currently this T-1 is only being used for outbound traffic.

Dianna

paolo bevilacqua · ‎07-10-2008

Like:

dial-peer voice 1234 voip

destination-pattern 1234

session target ipv4:x.x.x.x

codeg g711u

no vad

dtmf-relay rtp-npe

Please rate post if it does!

dfhensley · ‎07-10-2008

This didn't work for me. When calling the number I get dead air, no ring back.

Thanks

Ayodeji Okanlawon · ‎07-10-2008

can you post your full config here

Please rate all useful posts

dfhensley · ‎07-11-2008

Attached id my current config. It is configured in call manager.

Thanks for the help.

Dianna

paolo bevilacqua · ‎07-11-2008

Does the CM knows about the called DID?

Next step would be debugs like "cch323" with "term mon".

cposti01 · ‎07-10-2008

num-exp

Ayodeji Okanlawon · ‎07-11-2008

Your dial-p voice 411 below specifies a 4 digit number. However you said the inbound number is 800

can you tell me the full number delievered to your gateway.

You can know this by doing a dbug isdn q.931 and place a test call to the number...

dial-peer voice 411 voip

destination-pattern [0-8]...

progress_ind setup enable 3

modem passthrough nse codec g711ulaw

session target ipv4:10.34.0.11

Please rate all useful posts

dfhensley · ‎07-11-2008

This is the message I got when I did the debug and called the number. Telco is suppose to be sending 4191 as the dnis. The whole number is 877-367-4191

Thanks,

Dianna

Jul 11 13:46:09.132: ISDN Se0/0/1:23 Q931: TX -> CONNECT pd = 8 callref = 0x807D

Jul 11 13:46:09.168: ISDN Se0/0/1:23 Q931: RX <- CONNECT_ACK pd = 8 callref = 0x007D

Jul 11 13:46:09.168: ISDN Se0/0/1:23 **ERROR**: call_progress: DEV_CONNECTED VOICE ERROR: Bearer capability not available(0x3A): b channel 2 call id 0

x28CC

Ayodeji Okanlawon · ‎07-11-2008

I need to see the full debug..including the part that showed the calling and called number and also the cuase code..

send the full output

Please rate all useful posts