T1-CAS MGCP Pilot Number

Unanswered Question
Jul 10th, 2008


im configuring a T1-CAS E&M using MGCP. everything seems more or less alright with a few exceptions.

i need to route calls to my AA. how do you do this with this type of setup. Note this T1-CAS does not pass CLID information.

secondly im testing with a connection plar to a test phone.

when i make a call from the PSTN to the IP Phone i hear no ringback from my Land Line phone that im using. the ip phone rings as it should and if i pickup everything works (Two way communication).

any help would be appreciated

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
a.gooding Fri, 07/11/2008 - 16:07

i should have also been a little more specific. i can use connection plar to route to my AA right now but as i understand it this should not be used. how will the number translate to the pilot number since the CCM controls everything?


This Discussion