telnet issue

Unanswered Question
Jul 11th, 2008

hi everyone,

please i have an issue with my routers,from R2 i can telnet to R1 int serial 0/3/0:0 ip address,but i cannot telnet fron R1 to R2 int serial0/3/0:0 ip address.please what could be wrong attached are the configs.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
patrickvanham Fri, 07/11/2008 - 01:48

ACL 23 on R2 doesn't permit the telnet session. The ACL is not defined on R1, which is the reason it works there.

Rupesh Kashyap Fri, 07/11/2008 - 04:53

1. Create an ACL on R2 router and permit Telnet for source R1.

2. At the last line of ACL, user Log words like

deny ip any any log

3. Try if it will not work, then run debug on the interface S0/3/0:0 on router 2.


This Discussion