07-11-2008 02:12 AM - edited 02-21-2020 03:49 PM
Hello,
I'm trying to configure a SSL VPN tunnel via SDM on a 877 Router. The router gets the public IP address dynamically from the ISP, so I have configured the DDNS to access remotely to the router. I would like to know if it's possible to configure the SSL VPN to support the dynamic IP via SDM o CLI.
Regards
Gerard
Solved! Go to Solution.
07-22-2008 12:41 AM
Seems like i have fixed the problem using:
webvpn gateway gateway_1
ip interface Dialer0 port 443
ssl trustpoint local
inservice
However when the router is rebooted, it results in this error:
Invalid ip address First configure an IP address for the gateway
Any idea how to delay the webvpn commands at startup until dialer0 gets a dynamic IP ?
07-17-2008 02:13 PM
Use this SSL VPN Client (SVC) on IOS with SDM Configuration Example .
http://www.cisco.com/en/US/products/ps6496/products_configuration_example09186a0080720346.shtml
07-17-2008 10:34 PM
Hi owillins,
Sorry, but this configuration example is only for static public IP, and I need a config example for dynamic DNS or know if it is possible.
regards
07-18-2008 05:52 AM
I'm also looking for an answer to this question. Anybody with SSL VPN and dynamic DNS experience please assist.
07-22-2008 12:41 AM
Seems like i have fixed the problem using:
webvpn gateway gateway_1
ip interface Dialer0 port 443
ssl trustpoint local
inservice
However when the router is rebooted, it results in this error:
Invalid ip address First configure an IP address for the gateway
Any idea how to delay the webvpn commands at startup until dialer0 gets a dynamic IP ?
07-22-2008 12:50 AM
Hi joelau007,
I will try it later, and let you know.
Regards
08-05-2008 05:41 AM
Finally I configured the webvpn like you, and it works for me. I have reload the router, and can access without any problem.
Thank You!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide