07-11-2008 11:28 AM - edited 03-03-2019 10:41 PM
I have a client that was using thier Merlin Magix PBX to handle the inbound T1. The CSU\DSU failed and they were unable to obtain a new card that could support it. I am installing a 2600 router with a 1MFT-T1 card and the original wic 1T serial card that connected to the PBX. I have the data connected and running fine on channels 1 -12 from the T1 on the controller card, but I am not sure how to configure the phone channels on 13-23 to use the wic 1T serial card to connect and talk to the PBX??
Thanks
07-11-2008 11:52 AM
you need 2 ports
http://www.cisco.com/en/US/prod/collateral/routers/ps5855/product_data_sheet0900aecd8028d2db.html
[Pls RATE if HELPS]
07-11-2008 12:19 PM
So I can't use the serial card. I need either a dual port card can I use 2 1MFT cards? If I have the 2 ports I am guessing I setup each port for thier respective channels and one port will accept the incoming T1 and the other will go into the CSU/DSU port on the Phone switch? What do I need in the config so that it understands to send channels 13-23 from the T1 into the other MFT port?
Thanks
07-11-2008 01:54 PM
you need one card with 2 ports
how to configure it
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008010f05d.shtml
sorry, couldn't find a good example
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide