ACL in interface vlan (WS-6500-E)

Unanswered Question
Jul 12th, 2008

I applied two ACL (in-out)in my interface vlan in a 6506-E router to restrict some connections in my network; ACL are working fine but ACL counters don't show hits those match, only the deny line at the end shows counters increasing.

Is it the correct way to apply ACL in a interface vlan (layer 3) in a WS-6500-E?

Please, let me know your comments.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Edison Ortiz Sat, 07/12/2008 - 08:22

That's expected in the 6500 as packets are fast-switched, not process-switched.




dreardon Sat, 07/12/2008 - 09:09

Have you tried the following command?

Switch#show tcam interface Vlan3 acl in ip


This Discussion