New install - Can't find AP's

Unanswered Question
Jul 12th, 2008
User Badges:

Hi,


Just starting out with our new 2106 controller and 3 1252's. I have PoE injectors on the AP's (AIR-PWRINJ4), but I get the same problem if I plug in to the WLC ( i know its not enough power, just trying it out).


All I seem to get are all lights flashing on 2 of the AP's I have tried. The closest diagnostic I can pull out of the troubleshooting table online is that there isn't enough power. The lights are as follows:


Ethernet blinking Green

Status Blinks green, blue, red (power issue?)

Radio blinks amber


Again, there really isn't a chart that says what this problem could be, I am just going off of the status code. I logged in the console and ran debug lwapp events enable and see nothing...


Thanks,


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Sat, 07/12/2008 - 11:24
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Well for one, the power injector you are using is correct for the 1252. That will power both radios up. The problem you see is the LAP not joining the wlc. You have to configure the 2106 and then have the 1252 join the wlc and you will be good to go.


http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080665cdf.shtml


http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml


http://www.cisco.com/en/US/docs/wireless/technology/poe/technical/reference/Power.html#wp45170



adrian.h Sun, 07/13/2008 - 17:00
User Badges:

Hi,

Thanks for the response. Turns out for some reaosn, all the changes I had been saving didn't I chagned them all back and rebboted the controller and all is well!


Actions

This Discussion