cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
372
Views
0
Helpful
2
Replies

New install - Can't find AP's

adrian.h
Level 1
Level 1

Hi,

Just starting out with our new 2106 controller and 3 1252's. I have PoE injectors on the AP's (AIR-PWRINJ4), but I get the same problem if I plug in to the WLC ( i know its not enough power, just trying it out).

All I seem to get are all lights flashing on 2 of the AP's I have tried. The closest diagnostic I can pull out of the troubleshooting table online is that there isn't enough power. The lights are as follows:

Ethernet blinking Green

Status Blinks green, blue, red (power issue?)

Radio blinks amber

Again, there really isn't a chart that says what this problem could be, I am just going off of the status code. I logged in the console and ran debug lwapp events enable and see nothing...

Thanks,

2 Replies 2

Scott Fella
Hall of Fame
Hall of Fame

Well for one, the power injector you are using is correct for the 1252. That will power both radios up. The problem you see is the LAP not joining the wlc. You have to configure the 2106 and then have the 1252 join the wlc and you will be good to go.

http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080665cdf.shtml

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml

http://www.cisco.com/en/US/docs/wireless/technology/poe/technical/reference/Power.html#wp45170

-Scott
*** Please rate helpful posts ***

Hi,

Thanks for the response. Turns out for some reaosn, all the changes I had been saving didn't I chagned them all back and rebboted the controller and all is well!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: