cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
555
Views
0
Helpful
5
Replies

"No translation group found for" msg!

troubleshoooter
Level 1
Level 1

Hello guys,

our network guys had implemented MPLS, however, the setup is placing a router in the front of the internet firewall where it has 192.168.x.x interface IP address. I've given the firewall interface IP address on 192.168.x.x segment. access list also is given to that IP address.

PROBLEM :-

when our network guy tries to access the firewall, the NAT is not working and I get this message

3|Jun 23 2008 18:03:41|305005: No translation group found for tcp src MPLS:192.168.xx.x dst inside:xxx.xx.x.xx (type 8, code 0)

however the inside segment is also 192.168.xx.xx!

what do I get this message and NAT doesn't work?

the destination IP address is behind two firewalls extra

is it because the source is a private segment?

pleaseeeeeeeeeeeeeeeeeeee help me with this issue my boss is pressuring me into it :(!

5 Replies 5

a.alekseev
Level 7
Level 7

show the configuration

interfaces configuration?

interface GigabitEthernet0/0

no nameif

no security-level

no ip address

!

interface GigabitEthernet0/0.1

vlan 10

nameif internet

security-level 0

ip address 62.xxx.xx.x 255.255.255.192 standby 62.xxx.xx.xx

!

interface GigabitEthernet0/0.2

vlan 20

nameif DMZ1

security-level 0

ip address 192.168.93.1 255.255.255.0 standby 192.168.93.2

!

interface GigabitEthernet0/0.3

vlan 60

nameif mpls

security-level 0

ip address 192.168.80.2 255.255.255.248 standby 192.168.80.3

!

interface GigabitEthernet0/1

nameif internal

security-level 100

ip address 192.168.95.1 255.255.255.0 standby 192.168.95.41

!

interface GigabitEthernet0/2

no nameif

no security-level

no ip address

!

interface GigabitEthernet0/2.1

vlan 30

nameif DMZ

security-level 50

ip address 192.168.94.1 255.255.255.0 standby 192.168.94.2

!

above is the interfaces configuration, I don't know where is your concern at??

We need the entire configuration.

this firewall has a lot of configuration and I cannot just copy the entire configuration, so you might need to tell me where exactly your interest?

nat

global

static

interfaces

acl

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: