service-policy output voice-only

jiaxiongxiao · ‎07-14-2008

Hi, when i enter "service-policy output voice-only" in int BVI1 on a Cisco 878 (G.SHDSL), it throws an error saying, "Class Based Weighted Fair Queueing not supported"

Can i put this line in int ATM0 ?

paolo bevilacqua · ‎07-14-2008

Hi,

It should be done as follows:

Remove BVI and "bridge irb". Configure an ATM subinterface point-to-point with the IP address, "atm route-bridging" and PVC. Under PVC apply the service policy.

please rate post if it helps!

jiaxiongxiao · ‎07-14-2008

Hi Bevilacqua,

Thanks so much for replying so quickly.

Can i post the configs here ?

paolo bevilacqua · ‎07-14-2008

Hi,

I understand the config that you have now.

Make the suggested changes and if doesn't work, then post modified config.