07-14-2008 01:45 AM
Hi, when i enter "service-policy output voice-only" in int BVI1 on a Cisco 878 (G.SHDSL), it throws an error saying, "Class Based Weighted Fair Queueing not supported"
Can i put this line in int ATM0 ?
07-14-2008 01:50 AM
Hi,
It should be done as follows:
Remove BVI and "bridge irb". Configure an ATM subinterface point-to-point with the IP address, "atm route-bridging" and PVC. Under PVC apply the service policy.
please rate post if it helps!
07-14-2008 03:44 AM
Hi Bevilacqua,
Thanks so much for replying so quickly.
Can i post the configs here ?
07-14-2008 03:58 AM
Hi,
I understand the config that you have now.
Make the suggested changes and if doesn't work, then post modified config.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide