Analog FXS/DID Issue

Unanswered Question
Jul 14th, 2008
User Badges:

Using the FXS/DID card. After all 10 digits are dialed from an outside phone to an IP phone configured with a DID on a group of 4 FXS/DID trunks on callmanager express, it takes 10 to 12 seconds of dead air for the IP phone to start ringing. Why would the CME take 10 to 12 seconds? Is it using the interdigit timeout for inbound calls over the DID trunk?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Tue, 07/15/2008 - 00:27
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, you should include a show run and "debug vpm signal" taken with "service timestamp debug msec" and "term mon" for an incoming call , else it's purely a guessing exercise.

Actions

This Discussion