Booting problem on SUP720

Unanswered Question
Jul 15th, 2008

Hi,

One of my 6500 is refusing to boot with it's new software image.

DKNCORA#sh boot

BOOT variable = disk0:s72033-advipservicesk9_wan-mz.122-18.SXF14.bin,12;sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF10.bin,1;

CONFIG_FILE variable =

BOOTLDR variable =

Configuration register is 0x2102

I want to upgrade from SXF10 to SXF14.

here's the reload output

Jul 15 08:09:01: %SYS-SP-5-RELOAD: Reload requested

Jul 15 08:09:01: %OIR-SP-6-CONSOLE: Changing console ownership to switch processor

Jul 15 08:09:01: %SYS-SP-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.

System Bo otstrap, Version 8.1(3)

Copyright (c) 19 94-20 04 by cisco Systems, Inc.

Cat6k-Sup720/SP processor with 524288 Kbytes of main memory

Autoboot executing command: "boot bootflash:"

Loading image, please wait ...

Self extracting the image... [OK]

Self decompressing the image : ##################################################################################################### [OK]

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) s72033_sp Software (s72033_sp-IPSERVICESK9-M), Version 12.2(18)SXF10, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by cisco Systems, Inc.

Compiled Fri 13-Jul-07 08:39 by kellythw

Image text-base: 0x40101040, data-base: 0x41473450

Any idea ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
dabrooks Wed, 08/06/2008 - 08:48

Hi,

Did you resolve this problem. I'm getting exactly the same but when using a Supy 32. Also the switch will get to the same stage, i.e. Image text-base:

and then start over the RP loading sequence.

Jerry Ye Wed, 08/06/2008 - 12:35

Hi,

For the newer software, you should remove the boot statement "boot system flash sup-bootflash:xxxxx" if you are running Native IOS. This file system is on the MSFC and it is not going to be used to boot up the switch.

Boot image should be stored in sup-disk0: or sup-bootdisk:.

HTH,

jerry

Actions

This Discussion