×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CCM 3.3 and Hunt Group

Unanswered Question
Jul 15th, 2008
User Badges:

Does anyone know why you would not be able to edit a Hunt Group anymore?

We are adding additional phones and users to an existing Hunt Group. The new phones are associated with the ac user and everything.

No matter where we place them in the Hunt Group TCD acts as if they're not there.

If we edit the Hunt Group and remove the current functioning phones and only place a couple lines from a new phone in it the call goes straight to voice mail.


Any ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Tue, 07/15/2008 - 10:06
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

add them again, restart CTI and TCD


HTH


javalenc


if this helps, please rate

tomahawk72 Wed, 07/16/2008 - 06:46
User Badges:

It turns out that it was the TCD service. We had restarted it in the past but at the same time we messed around with a lot of the line settings. So this time we just removed and re-added the lines to the group then restarted the service and all is well.


Thanks.

Actions

This Discussion