07-15-2008 08:21 AM - last edited on 03-25-2019 07:42 PM by ciscomoderator
I do not have Administrator userid and password.
Searched CCO with no success.
I know that default is cisco/cisco.
Solved! Go to Solution.
07-15-2008 09:19 AM
Use the same procedure as for any router model, send break via console at boot, etc ...
Please rate post if it helps!
07-15-2008 09:19 AM
Use the same procedure as for any router model, send break via console at boot, etc ...
Please rate post if it helps!
07-15-2008 09:40 AM
Da,
Thanks. I was using a terminal emulator that did not send
Password Recovery Procedures
http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_tech_note09186a00801746e6.shtml
Needs updating. No mention of UC500 anywhere on CCO that I can find.
-- j
07-15-2008 09:52 AM
Putty rulez.
Thanks for the appreciation and good luck!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide