Display LACP information on 6509 CaTOS

Unanswered Question
Jul 15th, 2008
User Badges:

All,


On 6509 with CaTOS 8.6(4), is there a command to display LACP local and neighbor status (such as up or down, slow mode or fast mode, passive and active)?

I have tried all options of "show lacp-channel", but I could not get the info I need, especially if LACP is up or down and slow or fast mode.


I know on 3750 IOS, you can use "show etherchannel" to get all the LACP information. It seems 6500 CaTOS does not have similar command. Is it true?


Thanks,


Li

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
garytayl Tue, 07/15/2008 - 11:29
User Badges:
  • Silver, 250 points or more

Hello Li,


Have you tried the following commands:



show port lacp-channel

show etherchannel port-channel

show etherchannel X detail (replace de X with the channel #)



Regards,

Gary

lizhu2008 Tue, 07/15/2008 - 11:38
User Badges:

Gary,

"show etherchannel port-channel" and "show etherchannel X detail" are IOS commands, and they are not available on CaTOS 8.6(4). But these two commands can give me all the information on other box such as 3750.


I have also tried "show port lacp-channel" on my box, but it did not show enough information as IOS commands do.


Any suggestion?


Thanks,


Li



rsohi Tue, 07/15/2008 - 11:53
User Badges:

Have you tried 'show lacp , 'show lacp info' or show lacp traffic'?

lizhu2008 Tue, 07/15/2008 - 13:41
User Badges:

I tried. 'show lacp info' gives me some useful information, but I still cannot see information like: slow/fast mode, the LACP state of each link, which can be easily seen from IOS commands such as 'show etherchannel ...'.


Li

rsohi Tue, 07/15/2008 - 13:52
User Badges:

Hi Li, try the 'show channel info' command this might do the trick.


regards,

Raj

lizhu2008 Tue, 07/15/2008 - 14:01
User Badges:

Below is what I got:

Console> (enable) show channel info

No ports channelling


I guess it is because I am using LACP instead of PAGP, am I right?


Li

rsohi Tue, 07/15/2008 - 14:13
User Badges:

you might be right on that. Gary above stated to use 'show port lacp-channel'. What if you use 'show port lacp-channel info' does that provide more detail?

Actions

This Discussion