07-16-2008 03:17 AM - edited 03-03-2019 10:45 PM
I am building a home lab. I have 4 2620 routers and 4 3550 switches. My question is can I use one of this routers to access the other routers and switches rather that moving the console cable every time I access the other devices? Also can one of the routers be used as a frame relay switch? Some one had a diagram and configuration posted previously I just can't find it.
07-16-2008 03:24 AM
Hi,
Actually if you configure properly you can access everything from everywhere via telnet, no console cables are needed unless you lock yourself out of something.
And yes the router can be used as a basic frame-relay switch good for lab purposes.
please rate post if it helps!
07-16-2008 03:27 AM
you'd better try dynamips.
http://www.ipflow.utc.fr/blog/
can I use one of this routers to access the other routers and switches rather that moving the console cable every time I access the other devices?
if you have IP connectivity so you can use telnet.
for the LAB environment
!
conf t
line vty 0 4
logg sync
no login
privilege level 15
!
can one of the routers be used as a frame relay switch?
Yes, you can. But you have to have serial cards and cables.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: