07-16-2008 03:17 AM - edited 07-03-2021 04:10 PM
Does anyone know how to recovery from this 1130 AP. The flash is deleted. I tried to search the recovery steps but there is no document on this.
Thanks!
ap: dir
List of filesystems currently registered:
flash[0]: (read-write)
xmodem[1]: (read-only)
null[2]: (read-write)
tftp[5]: (read-only)
ap: help
? -- Present list of available commands
arp -- Show arp table or arp-resolve an address
boot -- Load and boot an executable image
cat -- Concatenate (type) file(s)
clear_ether -- clear ethernet port statistics
copy -- Copy a file
delete -- Delete file(s)
dir -- List files in directories
dump_save_regs -- dump saved regs in OCM
etest -- test emac driver code
ether_init -- initialize ethernet port
flash_init -- Initialize flash filesystem(s)
format -- Format a filesystem
fsck -- Check filesystem consistency
help -- Present list of available commands
init_pci -- initialize pci bridge
led_test -- cycle led patterns
memory -- Present memory heap utilization information
mkdir -- Create dir(s)
more -- Concatenate (display) file(s)
rename -- Rename a file
reset -- Reset the system
reset_gpio -- reset gpio
rmdir -- Delete empty dir(s)
set -- Set or display environment variables
set_baud -- set baud rates
set_gpio -- set gpio
set_sleep -- Pause (sleep) for a specified number of seconds
show_ether -- show ethernet port statistics
show_pci -- show pci setting
switch status -- report push button switch status
tar -- extract or listing a tar file
test ram -- read at address
tftp_init -- Initialize tftp file system
type -- Concatenate (type) file(s)
unset -- Unset one or more environment variables
version -- Display boot loader version
ap:
ap: boot
Loading "flash:/c1130-k9w7-mx.124-10b.JA/c1130-k9w7-mx.124-10b.JA"...flash:/c1130-k9w7-mx.124-10b.JA/c1130-k9w7-mx.124-10b.JA: magic number mismatch: bad
mzip file
Error loading "flash:/c1130-k9w7-mx.124-10b.JA/c1130-k9w7-mx.124-10b.JA"
Interrupt within 5 seconds to abort boot process.
Boot process failed...
ap: dir
07-22-2008 08:09 AM
Follow the URL for the reloading the image in access point which will help you :
05-28-2014 01:06 AM
ap: boot
Loading ""...: permission denied
Error loading ""
Interrupt within 5 seconds to abort boot process.
Boot process failed...
05-28-2014 02:07 AM
HI,
Please check this to recover IOS:
https://supportforums.cisco.com/document/31571/cisco-aironet-access-points-ios-recovery
or Check this:
http://tech.jocke.no/2012/05/17/how-to-recover-ap-from-ios-failure/
Regards
Dont forget to rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: