Cisco 857 - Hairpinning

Unanswered Question

How would I go about enabling hairpin routing?


I need the Cisco to take a packet from an internal device that's destined for the Di0 IP to be forwarded back internally according to the existing port forwarding rules.


No-one seems to know how, surely there's a guru out there that knows how to get it done!


(Current config attached)



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Wed, 07/16/2008 - 21:09
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

try to make an loopback interface and make nat insdie


on this loopback make apply a route map the redirect matched traffic by an acl to use an exit interface in the set command statment

*not sure about it


but, good luck


if worked rate :)

Actions

This Discussion