jtapi subsystem is out of order

Unanswered Question
Jul 17th, 2008

Hi

I finished to install UCCX 5.0(2) with CUCM 6.1.2 but the UCCX is in "Partial Service" I could not to configure any more. From the logs I saw "Jtapi substems is out of service". I tried many suggestions from Cisco documentation, but the problem is that the errors so

MIVR-SS_TEL-7-UNK: Number of CTI ports 0 (this is a new installation and I want create the CTI port from CRS)

MIVR-SS_TEL-1-SS-OUT_OF_SERVICE and Cause=1

MIVR-GENERIC-3-ModuleRunTimeFailure

these messages are different from the messagges about the documentation.

What I have to do?

Thanks for the help

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pklos Thu, 07/17/2008 - 01:45

You need to create JTAPI (CTI) Port Group using CRS web administration interface.

--

regards,

PK

cunisanti Thu, 07/17/2008 - 02:06

I tried to do your suggestion, but the result was failed. I though because the service is down

What other suggestion do you have?

Thanks for the help

Actions

This Discussion