NAT and Routing

Unanswered Question
Jul 17th, 2008

I want to configure a 2811 such that when internal PCs wants to access a server on the Internet at port 2823 and a certain IP range. It will use the second WAN link and NAT accordingly. How can I achieve this?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Thu, 07/17/2008 - 01:04

Simply use a specific route for that address or address, pointing to the link you want.

laichenkang Thu, 07/17/2008 - 01:18

How do I perform NAT for the second WAN link? I already have NAT that goes to the primary WAN link.

Paolo Bevilacqua Thu, 07/17/2008 - 01:24

under interface

ip nat outside

in global.

ip nat source inside list XXX interface X/Y overload

Please rate post if it helps!


This Discussion