07-17-2008 03:50 AM - edited 03-03-2019 10:46 PM
I am trying to set up an 871 router to connect to DSL over PPPoE. As far as I can tell, it is set up correctly, but it doesn't look like it is negotiating properly. I have attached the config as well as the output from the debug ppp negotiation.
Am I missing something in the cofiguration? I am not real familiar with DSL.
Thanks
07-17-2008 04:26 AM
why i cant see any NAT deployment
and also why u configure chap and pap
use one
07-17-2008 04:40 AM
I am not worried about NAT, I can add that once I get the DSL up and running. I configured both PAP and CHAP as I don't know which one Bell South uses, and the tech support person I spoke with couldn't tell me.
07-17-2008 04:52 AM
this is a sample config use it as refrence
CPE!ip dhcppool MyPool
network 10.0.0.0 255.0.0.0
default-router 10.0.0.1
!
interface Ethernet0/1
no ip address
pppoe enable
pppoe-client dial-pool-number 1
!
interface Ethernet0/0
ip address 10.0.0.1 255.0.0.0
ip nat inside
!
interface Dialer0
ip address negotiated
encapsulation ppp
dialer pool 1
ip mtu 1492
ip nat outside
ppp authentication chap callin
pppchap password mysecret
!
ip nat inside source list 101 interface Dialer0 overload
access-list 101 permit ip 10.0.0.0 0.255.255.255 any
!
ip route 0.0.0.0 0.0.0.0Dialer0
rate if helpful
07-17-2008 04:52 AM
interface Dialer1
no ip address x.x.x.x 255.255.255.248
ip address negotiated
no ppp authentication chap pap callin
ppp authentication chap callin
ppp chap hostname username@bellsouth.net
ppp chap password password
no ppp pap sent-username username@bellsouth.net password password
no ip route 0.0.0.0 0.0.0.0 74.165.50.205
no ip route 0.0.0.0 0.0.0.0 68.213.6.193
ip route 0.0.0.0 0.0.0.0 Dialer1
and show again
deb ppp neg
deb ppp auth
07-17-2008 08:47 PM
Do you know if it worked?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide