Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
268
Views
5
Helpful
1
Replies

Connecting CCM6 with router with E1 R2-signaling

connect101
Level 1
Level 1

‎07-17-2008 07:15 AM - edited ‎03-15-2019 12:02 PM

Hi,

Ho to connect a CCM6 with a router that use an interface card configured with a E1 PRI Signaling.

The gateway protocol is MGCP.

I've tryed to configure it, but, I've not seen a R2 signalisation.

I just see : PRI EURO, PRI ISO QSIG E1, PRI AUSTRALIAN

What is the correct configuration for an R2 Signaling.

Thank You

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎07-17-2008 07:53 AM

Hi, you cannot use MGCP with E1 R2. You must use H.323 or SIP.

There are no versions, configurations or workarounds to avoid the above fact.

please rate post if it helps!

Customers Also Viewed These Support Documents