Sync Archive Failed

murilo.coutinho · ‎07-17-2008

Hi all,

I am getting the following message when I try a sync archive. Does anyone no what could be the reason. Credentials seems to be all right.

Protocol ==> Telnet

CM0057 PRIMARY RUNNING Config fetch SUCCESS, archival failed for akl-application Cause: CM0002: Could not archive config Cause: Device may not be reachable, may be in suspended state or credentials may be incorrect. Action: Verify that device is managed, credentials are correct and file system has correct permissions. Increase timeout value, if required. Action: Verify that archive exists for device. CM0060 VLAN RUNNING Config fetch SUCCESS for akl-application, version number 1412 archived.

Farrukh Haroon · ‎07-18-2008

RME Version?

Which Device?

Regards

Farrukh

Joe Clarke · ‎07-19-2008

See this thread:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&topicID=.ee71a02&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc1533c

This problem is usually indicative of a corrupt archive, and removing the device from RME then re-adding it usually solves the issue.