ACS 4.2 HW appliance Change speed + duplex

Unanswered Question
Jul 18th, 2008
User Badges:

On The ACS Hw appliance how do you configure the speed and duplex ? Currently my sw is set to 100 full and my ACS keeps on negotiating to 100 half. Any suggestions ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


Each NIC is configured to automatically detect the speed and duplex mode of the network.

Please observe the following cabling restrictions for 10BASE-T, 100BASE-TX, and 1000BASE-TX networks:

•For 10BASE-T networks, use Category 3 or greater wiring and connectors.

•For 100BASE-TX and 1000BASE-TX networks, use Category 5 or greater wiring and connectors.

•The maximum cable run length is 328 feet (ft) or 100 meters (m).



This Discussion