GLBP command problem

Unanswered Question
Jul 19th, 2008


I am trying to set-up GLBP on new 6506-E chassis we recently received with Sup720-10G-VSS supervisor blades. The IOS is a modular IOS which does support GLBP going by the feature navigator, but when you create a interface there is no commands for GLBP.

I have noticed the following command at the foot of the sh ver -

Patching is not available since the system is not running from an installed image. To install please use the "install file" command

But l am not sure if this is something that has not been installed on the chassis? As l carry out a show install running, l get the following -

System is currently not running from installed software?

Has anyone configured GLBP on teh 720-VSS or came across a similar issue.



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Giuseppe Larosa Sat, 07/19/2008 - 23:36

Hello James,

from your sh ver


you have ip base feature set

for example in advipservicesk9_wan-vz.122-33.SXH2a.bin

I can put the glbp command under an SVI interface

I would put another image of advanced ip services feature set and try with that image

sometimes, Feature navigator makes mistakes

Hope to help



This Discussion