Locale Installation Order with Pub/Sub

Unanswered Question
Jul 19th, 2008
User Badges:

Hi,

I'm installing CM cluster 4.2 (1 pub and a few subs).

Wish to apply user/network locale for the cluster.


Documentation recommends


1. Install Pub

2. Install Subs

3. During non Business Hours

3.1 Install locale executable on pub at first.

3.2 Install the same executable on the subs.

3.3 Reload all the servers in the cluster.

4. Apply installed locale value where applicable (e.g. phones)


My question: is the following possible ?


1. Install Pub

2. During non Business Hours install locale executable on the pub and reload the server (cluster contains only pub)

3. Apply installed locale value where applicable (e.g. phones)

4. A few days later install subscribers in the cluster (1 or more)

5. Then run locale installer on the subscriber servers the same way as for pub, reload then.


A little silly question IMHO, but I am in doubt.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Rob Huffman Sat, 07/19/2008 - 07:18
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Tobivan,


This is actually an excellent question (not silly at all :)


This method shouldn't cause you any unforeseen problems. This is the same way it would happen if you were adding new Subs to an existing cluster somewhere down the road.


Have a great day!

Rob

Actions

This Discussion