07-21-2008 08:14 AM - edited 02-21-2020 02:56 AM
How does one reset the PIX 501 to factory defaults when you do not have the enable password?
Thanks!
07-21-2008 08:33 AM
You will need to do the password recovery as reseting to factory defaults requires to be in enable config mode.
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtml
after you recover password then issue the command.
example
PIX(config)#configure factory-default
HTH
Jorge
07-21-2008 09:43 AM
Thanks- that's exactly what I was looking for.
I knew it had to be out there somewhere, but I just couldn't locate it.
I am all set now; thanks again.
07-21-2008 10:19 AM
Lynney,
You're welcome, if problems let us know.
Rgds
pls rate any helful post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
