Configure static ip routes on CS ACS-SE

Answered Question
Jul 21st, 2008

Hi!

We use a Cisco Secure ACS Solution Engine, running V4.2.0.124.3.

The Appliance hast two Ethernet Ports.

- We need to know how to configure an IP-Adress on the second port. But more:

- We need to know how to configure static IP-routes on this device.

Is anyone out there to tell us how to do it ?

Regards, Markus

I have this problem too.
0 votes
Correct Answer by Jagdeep Gambhir about 8 years 6 months ago

Markus,

In acs you can only use one NIC and there is no way you can set static routes on it.

Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors. Each Ethernet connector provides all the functions of a network expansion card and supports the 10BASE-T, 100BASE-TX, and 1000BASE-TX Ethernet standards.

Each NIC is configured to automatically detect the speed and duplex mode of the network.

Regards,

~JG

Do rate helpful posts

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jagdeep Gambhir Mon, 07/21/2008 - 09:32

Markus,

In acs you can only use one NIC and there is no way you can set static routes on it.

Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors. Each Ethernet connector provides all the functions of a network expansion card and supports the 10BASE-T, 100BASE-TX, and 1000BASE-TX Ethernet standards.

Each NIC is configured to automatically detect the speed and duplex mode of the network.

Regards,

~JG

Do rate helpful posts

Actions

This Discussion