lgijssel Wed, 07/23/2008 - 00:30

Did you actually perform the config below?


Router# vlan database

Router(vlan)# vlan vlan_ID

Router(vlan)# exit


Your description is typical for having not, so please check the link I sent you and verify that the "show interface vlan xx" reports up/up as the status.


regards,

Leo

deepa.muralidharan Wed, 07/23/2008 - 00:38

Leo,

I have created it exactly the way mentioned. No change seen.

Also, when I see the vlan status as "active" in "sh vlan" output; doesn't it mean that the L2 status is up ?




Regards,

Deepa

lgijssel Wed, 07/23/2008 - 01:05

I would think so, yes but that does not explain you seeing what you wrote in your second post: The output of sh int vlan gives : Vlan is down, line protocol is down

That vlan can only be down when there are no ports (including trunks) that forward this vlan. The only situation that can possibly explain that would be when there is only one port that carries the vlan and this port is not connected.

This means you may have connected to the wrong port; a non-existing vlan seemed like a more plausible cause.


regards,

Leo

Actions

This Discussion