Mesh networking

Unanswered Question
Jul 22nd, 2008
User Badges:

Equipments being used:


1) Cisco 2106 WLAN controller

2) Cisco 1131AG access points (LWAPP mode)

3) Cisco catalyst 2950 switch


Hi,


My setup is as follows:

My access point is registered with the WLAN controller via the switch. When i try to change the mode of the access point to bridge. It does not accept the change. My aim is to create a mesh network using 1131AG access points.So my question is:


Can I setup a mesh network using Cisco 1131AG access point in LWAPP mode or do i need to change them to autonomous mode?


Any documentations or comments will be helpful.


Thanks in advance.


Regards

Sri









  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.8 (3 ratings)
Loading.
Siva Rama Krish... Mon, 07/28/2008 - 02:50
User Badges:

Hi Sri


You need to upgrade your ios to mesh ios which is available in cisco site

you can connect up to 4 ap's ads mesh access point

sdeva1986 Mon, 07/28/2008 - 12:27
User Badges:

Thank You for the help


Now, i can finally setup my mesh network :D

dennischolmes Tue, 08/12/2008 - 11:53
User Badges:
  • Gold, 750 points or more

The mesh trains are due to reconverge shortly so you will have all the 5.1x features available as well.

bgust3412 Wed, 08/20/2008 - 06:19
User Badges:

You can do this but you need 4.1.191M. It's the code that will enable you to put the AP in bridge mode. Here are the release notes.



Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode