Gbic port unusable

Unanswered Question
Jul 23rd, 2008
User Badges:


error massage:

POST: Inline Power Controller Tests : Begin

POST: Found inline power controller write failure, inst 0

POST: Inline Power Controller Tests : End, Status Failed


Gbic port not functions.

why this happen coz of hardware or software?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
lgijssel Wed, 07/23/2008 - 01:15
User Badges:
  • Red, 2250 points or more

Too bad; POST-failures are mostly hardware.


Leo

LUIGI PIETRONAVE Fri, 03/20/2009 - 14:59
User Badges:

Hi,

I've got the same issue. To be more specific I found that i went into this issue only when, in a 3560-24P, i insert both sfp.


If i insert only one of them all is working fine


Had You any news ?


regards


Luigi

Leo Laohoo Sun, 03/22/2009 - 17:57
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

In enable mode, try the command "show post". The results should be "End, Status Passed". If the result comes back as "failed" then you need to RMA the switch.

Actions

This Discussion