Gbic port unusable

ahmadhelmirudinridzuan · ‎07-23-2008

error massage:

POST: Inline Power Controller Tests : Begin

POST: Found inline power controller write failure, inst 0

POST: Inline Power Controller Tests : End, Status Failed

Gbic port not functions.

why this happen coz of hardware or software?

lgijssel · ‎07-23-2008

Too bad; POST-failures are mostly hardware.

Leo

LUIGI PIETRONAVE · ‎03-20-2009

Hi,

I've got the same issue. To be more specific I found that i went into this issue only when, in a 3560-24P, i insert both sfp.

If i insert only one of them all is working fine

Had You any news ?

regards

Luigi

Leo Laohoo · ‎03-22-2009

In enable mode, try the command "show post". The results should be "End, Status Passed". If the result comes back as "failed" then you need to RMA the switch.