Unanswered Question
Jul 23rd, 2008

my main network is 10.9.2.XXX

i have sub networks ie. 10.2.x.x, 10.3.x.x, 10.4.x.x, and so on!

if i log into the 10.9.2.x network i can go into any sub network.

but if i connect my laptop to ANY sub network of course my ip gets that sub networks ip. but i cannot talk to another sub network.

ie. if i am on network 10.2.x.x and i want to print to the printer on 10.6.x.x i cannot?

any ideas?

I have attached a subnetworks config...

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dhananjoy chowdhury Wed, 07/23/2008 - 05:57

I assume that all have the same security level

the command below will allow communication between the subnets.(but it will support only on IOS 7.0 and above)

hostname(config)# same-security-traffic permit inter-interface

Danny Guillory Jr Wed, 07/23/2008 - 06:10

ok well i am understanding that i eed to place this line in my 506E. Thats the 1 that all the 501's VPN into to create the vpn tunnel!

So i guess i need to update my pix506E to ios 7.0.

is taht coirrect?


This Discussion