cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
631
Views
5
Helpful
6
Replies

annoying messages on my core

ougwuoke
Level 1
Level 1

The loggs below is from my core.. the port bening refered to is my route switch moudle. should i change the trunking mode to DOT1Q. It is currently on ISL

2008 Jul 23 15:52:19 PDT -07:00 %PRUNING-6-TRIGJOIN:trunk 15/1- send trig Join

2008 Jul 23 15:52:20 PDT -07:00 %PRUNING-6-TRIGJOIN:trunk 15/1- send trig Join

2008 Jul 23 15:52:21 PDT -07:00 %PRUNING-6-TRIGJOIN:trunk 15/1- send trig Join

2008 Jul 23 15:52:22 PDT -07:00 %PRUNING-6-TRIGJOIN:trunk 15/1- send trig Join

2008 Jul 23 15:52:23 PDT -07:00 %PRUNING-6-TRIGJOIN:trunk 15/1- send trig Join

2008 Jul 23 15:52:24 PDT -07:00 %PRUNING-6-TRIGJOIN:trunk 15/1- send trig Join

2008 Jul 23 15:52:25 PDT -07:00 %PRUNING-6-TRIGJOIN:trunk 15/1- send trig Join

6 Replies 6

Adam Frederick
Level 3
Level 3

This message indicates that a VTP pruning message is triggered on the trunk because of a VLAN status change; 15/1 is the module number/port number.

This message is provided for information only.

It appears you have your syslog level at 6 for VTP Pruning messages. I would simply just lower the level to 5 for these specific messages since they are only informational. Doing this will make them go away.

Issue the following configuration command:

Console> (enable) set logging level pruning 5 default

thank you for your help.. the info you provided helped

Hello,

good idea but

shouldn't he move them to level 7 instead ?

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/6.x/configuration/guide/logging.html

Best Regards

Giuseppe

Thank you for the inform it helped

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello,

port 15/1 is the port to MSFC and you have a Cat6509 in hybrid mode.

You probably have some Vlans that are defined on the L2 supervisor that haven't a L3 counterpart on your MSFC (an SVI VLan X)

so VTP is pruning the link 15/1 for these vlans.

This is the meaning of this message

for VTP on CatOS

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/6.x/configuration/guide/vtp.html#wp1021050

Hope to help

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco