cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
563
Views
5
Helpful
2
Replies

Configure Trunk VLANs

MathieuJM_2
Level 1
Level 1

Hi,

I'm using LMS 2.6. I have a trunk port with some allowed VLANs. I try to easily add some VLANs to this trunk.

I have look in vlan assignment(CM) in CiscoView but i don't find any solution.

Finally i have done it with the CNA.

But i still wish to understand how to do it with LMS, and if possible not with a NetConfig.

Cheers,

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

Campus Manager 5.0 has a Trunk Port configuration UI that will allow you to do this. In Campus 4.0, you can do this by right-clicking on a trunk link in the Topology Map, and selecting Trunk Attributes.

Thank you for your answer. It works fine.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco