Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
431
Views
0
Helpful
2
Replies

Access issue with WLC 2106

Go to solution
amolhempour
Level 1
Level 1

‎07-24-2008 08:50 AM - edited ‎07-03-2021 04:13 PM

Hi, I have a WLC 2106 and 2 1250 APs connected to it. the controller works really good. all APs are associated.

The problem I have is that after a few days I cannot connect to the GUI interface or console.

I can still ping and trace the controller.

After i turn the controller off and back on it works again.

The internal temp show 56 C. Would this cause the problem ?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions
2 Replies 2

Go to solution
amolhempour
Level 1
Level 1
In response to jmmerritt

‎07-24-2008 12:56 PM

thanks, apparently there is new version out. I'll update to 5.1 and see if that would fix the problem

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card