route-map after tunnel end point

Unanswered Question
Jul 24th, 2008
User Badges:

Hello Folks. I have an ASA5510 with multiple tunnels terminating into it. Some sites require a hairpin bend out into the internet after terminating, this works fine with an applicable NAT statement, however, is it possible to use a route-map to route this traffic that would normally hair pin bend out the same interface back into the internet, but rather go out through another link on another host?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Wed, 07/30/2008 - 16:40
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

yes, you can

but not with route map because in ASA there is not route map


so u need first put the folowing command to allow the tunnel exit from the same interface where it is terminated orginally


issue the

same-security-traffic intra-interface

command in the global configuration mode


and for more configurations details use the following link will be useful for your case


http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807f9a89.shtml


good luck


Please, Rate if helpful

richardsav Sat, 08/02/2008 - 01:47
User Badges:

Thank you for the reply, will check out URL and let you know if it solves my problem. PS,where do I rate replies?

Marwan ALshawi Sat, 08/02/2008 - 03:30
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

cool :)

when u click for example on my reply

and read it

there is on the end of the post( bottom right corner) drop down manu chose the rate u find it proper for that post and click submit


good luck with your case


Actions

This Discussion